St. Timothy High School: Difference between revisions

Latest revision as of 18:08, 11 September 2025

System Specifications

FACP: Kidde VS4 FACP Location: Custodian's Office System Type: Single-Stage Addressable System Line Voltage: 120VAC NAC Voltage: 24VFWR System Coding: Temporal Strobes Synchronized: Yes Date of last known Upgrade: 2020 Year Opened: 2004

St. Timothy High School is a junior and senior high school located at 501 Sunset Drive, Cochrane, AB. It is operated by the Calgary Catholic School District. The school was built in 2004, and the fire alarm system was upgraded in 2020; only the pull stations are original.

System Specifications (2020-present)

This system took two months to install, starting in May 2020 and ending that summer.

FACP

The building is protected by a Kidde VS4 addressable fire alarm system. The panel is located in the custodian's office. The system runs Kidde's GSA addressable protocol, and the system coding is temporal.

Annunciators

There is a Kidde K-RLCD-C annunciator paired with a K-RLED24 annunciator at the main entrance, mounted inside an RA-ENC2 enclosure.

Notification Appliances

Most notification appliances are Kidde "Genesis" EGC-HDVM horn/strobes (white, ceiling-mount, no marking, set to 30 or 75cd).

Areas without drop ceilings have Kidde EG1R-HDVM horn/strobes (red, wall-mount, no marking, set to various candelas).

All washrooms have Kidde EGC-VM remote strobes (white, ceiling-mount, no marking, set to 75cd).

For outdoor notification, there is an Edwards WG4RN-HVMC weatherproof horn/strobe (red, no marking, set to 60cd) by the tarmac, and an Edwards CS405-8A-T weatherproof remote strobe (red, 110cd) outside the main entrance. The remote strobe was installed prior to the Kidde system.

Initiating Devices

Pull Stations

All pull stations are EST SIGA-270 addressable single-action pull stations.

Automatic Detection Devices

There are Kidde KI-PD optical addressable smoke detectors throughout the building.

Certain rooms have Kidde KIR-HD addressable 135°F fixed-temperature/rate-of-rise heat detectors.

All detectors installed on KI-SB bases.

There are Kidde "SuperDuct" GSA-SD addressable photoelectric duct smoke detectors on all air handling units, wired to Kidde GSA-LED remote indicators.

Modules

There are Kidde GSA-CT1 addressable monitor modules supervising the sprinkler system and tamper switches.

There are also Kidde GSA-CR addressable relay modules for various purposes.

There are Kidde GSA-IM addressable isolator modules on the SLC.

EOLs

There are Edwards EOL-P1 end-of-line resistors on all sprinkler and signal circuits.

Former System Specifications (2004-2020)

Former System Specifications

FACP: EST QuickStart QS1 FACP Location: Custodian's Office System Type: Single-Stage Addressable System Line Voltage: 120VAC NAC Voltage: 24VFWR System Coding: Temporal Strobes Synchronized: Yes Date of last known Upgrade: Feb 2020 Year Installed: 2004 Year Decomissioned: 2020

FACP

The building was protected by an EST QuickStart QS1 addressable fire alarm system. The panel was located in the caretaker's office. The system ran EST's Signature addressable protocol, and the system coding was temporal.

This panel was installed in 2016 as an emergency replacement for the original variant, which suffered a CPU failure.

Annunciators

There was a QSA-1-S cabinet in the main entrance vestibule, with an EST QS1-CPU-1 CPU and an SL30 card in it.

Notification Appliances

Most notification appliances were Edwards MB6-24 motor bells (6" gong) on EST "Integrity" 403-5A-R strobe plates (15cd).

The gym and shop had Edwards MB10-24 (10" gong) motor bells on EST "Integrity" 403-5A-R strobe plates.

For outdoor notification, there were three Edwards MB6-24 motor bells (6" gong), located at the front, by the staff parking lot, and at the tarmac.

There was also an Edwards CS405-8A-T weatherproof remote strobe (red, 110cd) above the bike rack; this was installed in February 2020 as a deficiency replacement for the original variant, and is still in use on the current system.

Initiating Devices

Pull Stations

All pull stations were EST SIGA-270 addressable pull stations. These are still in use on the Kidde system.

Automatic Detection Devices

There were EST SIGA-PS addressable photoelectric smoke detectors throughout the building.

Certain rooms such as the electrical room had EST SIGA-HRS addressable 135°F fixed-temperature/rate-of-rise heat detectors.

All detectors were mounted on SIGA-SB bases. Most were original, and some were deficiency replacements over the years.

There were EST SIGA-DH duct detector housings, on the air handling units and above some ceilings, with SIGA-PS addressable photoelectric heads inside them. These were connected to EST SIGA-LED LED indicators.

Modules

There were EST SIGA-CT1 addressable monitor modules supervising the sprinkler system and tamper switches.

There were also EST SIGA-CR addressable relay modules for various purposes.

There were EST SIGA-IM isolator modules on the SLC.

EOLs

There are Edwards EOL-P1 end-of-line resistors on all sprinkler and signal circuits.

List of known activations

September 21, 2020 - alarm at around 9:45 AM, activated by duct detector in air handling unit in gymnasium. Scent of smoke reported in gym and nearby areas prior to alarm. School was evacuated, Cochrane Fire Services responded and the cause was found to be a motor overheating, burning red hot and smoking from the electrical panel outputting 4x the rated current, due to FORTIS working on power. Alarm shut off after 30 minutes.

Gallery

An Edwards MB6-24 bell/strobe combo in the basement. (This alarm does not exist anymore)
This one was located by Room 209. Note the sticker on the bell. (This alarm does not exist anymore)
This bell/strobe was in the band room. Note the Incredibles logo on it, which was vandalized by the band teacher. This was a code violation, as the strobe flashes are not visible. (This alarm does not exist anymore)
An original EST SIGA-PS smoke detector in the stairwell. Also pictured is an Enforcer ceiling speaker. (This smoke detector does not exist anymore)
The QuickStart annunciator in the entrance. Note the new EST logo. (System has been replaced)
A pull station by the stairwell in the basement. This pull station is still installed on the Kidde system.

@@ Line 11: / Line 11: @@
 This system took two months to install, starting in May 2020 and ending that summer.
 ==== FACP ====
-The building is protected by a Kidde VS4 addressable fire alarm system. The panel is located in the caretaker's office. The system runs Kidde's GSA addressable protocol, and the system coding is temporal.
+The building is protected by a Kidde VS4 addressable fire alarm system. The panel is located in the custodian's office. The system runs Kidde's GSA addressable protocol, and the system coding is temporal.
 ===== Annunciators =====
-There is a Kidde K-RLCD-C LCD annunciator and a K-RLED24 LED annunciator at the entrance, on a rectangular silver metal plate.
+There is a Kidde K-RLCD-C annunciator paired with a K-RLED24 annunciator at the main entrance, mounted inside an RA-ENC2 enclosure.
 ==== Notification Appliances ====
-All notification appliances except for one are from Kidde's "Genesis" line of products.
+Most notification appliances are Kidde "Genesis" EGC-HDVM horn/strobes (white, ceiling-mount, no marking, set to 30 or 75cd).
-The main notification appliances are Kidde EGC-HDVM horn/strobes (white, ceiling-mount, no lettering, set to 30 or 75cd). There is one horn/strobe per classroom, and the library contains three horn/strobes.
+Areas without drop ceilings have Kidde EG1R-HDVM horn/strobes (red, wall-mount, no marking, set to various candelas).
-Open ceiling areas (the top floor atrium, gymnasium, band/music room and the shop) have Kidde EG1R-HDVM horn/strobes (red, wall-mount, no lettering, set to either 15, 75, or 110cd). The gym has four; two of the horn/strobes where the bell/strobes were, but the other two are in new locations.
+All washrooms have Kidde EGC-VM remote strobes (white, ceiling-mount, no marking, set to 75cd).
-All washrooms have an Kidde EGC-VM remote strobes (white, ceiling-mount, no lettering, set to 75cd).
+For outdoor notification, there is an Edwards WG4RN-HVMC weatherproof horn/strobe (red, no marking, set to 60cd) by the tarmac, and an Edwards CS405-8A-T weatherproof remote strobe (red, 110cd) outside the main entrance.  The remote strobe was installed prior to the Kidde system.
-For exterior notification, there is an Edwards WG4RN-HVMC weatherproof horn/strobe (red, no lettering, set to 60cd) by the tarmac, behind a wire grill.
-There is also an Edwards "Integrity" CS405-8A-T weatherproof remote strobe (red, 110cd) by the bike rack that was installed in early 2020 when the QuickStart was still in service; the only notification appliance to remain from the previous system.
 === Initiating Devices ===
 ==== Pull Stations ====
-All pull stations are the original EST SIGA-270 addressable pull stations. These were kept from the previous system as they are compatible.
+All pull stations are EST SIGA-270 addressable single-action pull stations.
 ==== Automatic Detection Devices ====
 There are Kidde KI-PD optical addressable smoke detectors throughout the building.
-Certain rooms have Kidde KIR-HD addressable 135°F fixed-temperature/rate-of-rise heat detectors. All detectors installed on KI-SB bases.
+Certain rooms have Kidde KIR-HD addressable 135°F fixed-temperature/rate-of-rise heat detectors.
+All detectors installed on KI-SB bases.
-There are Kidde GSA-SD two-wire photoelectric duct smoke detectors on each air handling unit and behind ceilings. They are connected to Kidde GSA-LED LED indicators.
+There are Kidde "SuperDuct" GSA-SD addressable photoelectric duct smoke detectors on all air handling units, wired to Kidde GSA-LED remote indicators.
 ==== Modules ====
 There are Kidde GSA-CT1 addressable monitor modules supervising the sprinkler system and tamper switches.
-There are also Kidde GSA-CR addressable control modules for shutting down the HVAC system and releasing the fire doors, wired to EST 1508-AQN5 magnetic door holders.
+There are also Kidde GSA-CR addressable relay modules for various purposes.
-There are Kidde GSA-IM isolator modules on the SLC.
+There are Kidde GSA-IM addressable isolator modules on the SLC.
 ==== EOLs ====
 There are Edwards EOL-P1 end-of-line resistors on all sprinkler and signal circuits.
@@ Line 60: / Line 59: @@
 There was a QSA-1-S cabinet in the main entrance vestibule, with an EST QS1-CPU-1 CPU and an SL30 card in it.
 ==== Notification Appliances ====
-Most notification appliances were Edwards MB6-24 motor bells (6" gong) on EST "Integrity" 403-5A-R strobe plates (15cd). These could also be found in the library, the music room, and the changerooms.
+Most notification appliances were Edwards MB6-24 motor bells (6" gong) on EST "Integrity" 403-5A-R strobe plates (15cd).
-The gym and shop had Edwards MB10-24 (10" gong) motor bells on EST "Integrity" 403-5A-R strobe plates due to higher ambient noise levels. There were three in the gym, and two in the shop.
+The gym and shop had Edwards MB10-24 (10" gong) motor bells on EST "Integrity" 403-5A-R strobe plates.
-For outdoor notification, there were three Edwards MB6-24 motor bells (6" gong), located at the front near the hill, one by the staff parking lot, and one at the tarmac.
+For outdoor notification, there were three Edwards MB6-24 motor bells (6" gong), located at the front, by the staff parking lot, and at the tarmac.
-There was also an Edwards CS405-8A-T weatherproof remote strobe (red, 110cd) above the bike rack; this was installed in February 2020 as a deficiency replacement for the original EST one, and is still in use on the current system.
+There was also an Edwards CS405-8A-T weatherproof remote strobe (red, 110cd) above the bike rack; this was installed in February 2020 as a deficiency replacement for the original variant, and is still in use on the current system.
 === Initiating Devices ===
 ==== Pull Stations ====
@@ Line 81: / Line 80: @@
 There were EST SIGA-CT1 addressable monitor modules supervising the sprinkler system and tamper switches.
-There were also EST SIGA-CR control modules for shutting down the HVAC system, and releasing the fire doors, wired to Edwards 1508-AQN5 magnetic door holders.
+There were also EST SIGA-CR addressable relay modules for various purposes.
 There were EST SIGA-IM isolator modules on the SLC.
@@ Line 98: / Line 97: @@
 StTimothyPull.jpeg|A pull station by the stairwell in the basement. This pull station is still installed on the Kidde system.
 </gallery>
-[[Category:Facilities]]
-[[Category:Facilities]]
 [[Category:Cochrane]]
 [[Category:Schools - Secondary]]
+[[Category:Kidde]]