Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

We have switched hosting. Sorry for the recent downtime. :)

Winfield Agriplex: Difference between revisions

From FireAlarmPedia
mNo edit summary
 
(13 intermediate revisions by the same user not shown)
Line 5: Line 5:
|  
|  
|-
|-
| FACP: EST 6601 <br />FACP Location: Lobby, Hall Side <br />System Type: Conventional <br />System Line Voltage: 120VAC<br />NAC Voltage: 24VFWR <br />System Coding: Continuous <br />Date of last known Upgrade: Mid-1990s <br />Year Opened: 1970s?
| FACP: Mircom FA-106<br />FACP Location: Lobby, Hall Side <br />System Type: Single-Stage Conventional <br />System Line Voltage: 120VAC<br />NAC Voltage: 24VFWR <br />System Coding: Temporal<br />Date of last known Upgrade: 2024<br />Year Opened: 1950s
|}
|}
'''Winfield Arena''' is an arena, located at 401 6 St E, Wetaskiwin County, AB. It was built in the 1970s, and the fire alarm system is most likely original except for the panel. The system will likely be upgraded this year.
'''Winfield Agriplex''' is a multi-use building located at 401 6 St E, Wetaskiwin County, AB. It consists of a hall and arena; it was originally built as the Winfield Arena (now Woody Johnson Arena) in the 1950s, and was expanded around 1986 to add the hall. The fire alarm system was upgraded around 1983 for the lobby and arena, the hall's bells are original; the fire alarm system was partially upgraded in 2024.
== System Specifications (1970s-present) ==
== System Specifications (1980s-present) ==
''NOTE: This system is pending further investigation. This page should not be used for official purposes.''
==== FACP ====
==== FACP ====
The building is protected by an EST 6601 conventional fire alarm system. The panel is located in the lobby, on the hall side, and is also noticeably mounted high. The system coding is continuous.  
The building is protected by a Mircom FA-106 conventional fire alarm system. The panel is located on the south the lobby near the hall, and is also noticeably mounted high. The system coding is temporal.
 
The FA-106 replaced an EST 6601 in 2024 after a panel failure.  
==== Notification Appliances ====
==== Notification Appliances ====
All notification appliances are Chubb 960-1032 vibrating bells (10” gong). There is also one installed outdoors for exterior notification.  
Most notification appliances in the lobby and arena hallways are Chubb 960-1033 vibrating bells (10” gong). There is also one installed outdoors for exterior notification.
 
There are some Edwards 439D-10AWC vibrating bells (10" gong) in the same areas, installed during 1986.
 
There is a Mircom BL-10B motor bell (10" gong) in the arena as a deficiency replacement for an Edwards 439D-10AWC.
 
The hall portion has Edwards 439D-6AWC vibrating bells (6" gong).  
=== Initiating Devices ===
=== Initiating Devices ===
==== Pull Stations ====
==== Pull Stations ====
Most pull stations are Sentron 303 conventional pull stations. <br> There are some Sentron 304 conventional two-stage pull stations, wired as single-stage.
The lobby and arena mostly have Sentron 303 conventional single-action pull stations.<br>There are some Sentron 304 conventional two-stage pull stations, wired as single-stage.
 
The hall has Mircom MS-401 conventional single-action pull stations; these replaced Edwards 274-111 conventional single-action pull stations in 2024.
==== Automatic Detection Devices ====
==== Automatic Detection Devices ====
Most heat detectors are Edwards 281C rate-of-rise/fixed heat detectors.  
There are Mircom 5601A conventional 135°F fixed-temperature/rate-of-rise heat detectors throughout the facility, installed in 2024.
 
These replaced Edwards 281C conventional 135°F fixed-temperature/rate-of-rise heat detectors throughout, with some Sentron 320 conventional 135°F fixed-temperature/rate-of-rise heat detectors.  


There is an FDD CR135 fixed-temperature heat detector in the Olympia Room as a deficiency replacement. There is no sprinkler system.
==== EOLs ====
There are two Edwards EOL-P1 end-of-line resistor plates on all circuits.
[[Category:Arenas]]
[[Category:Community Centres]]
[[Category:Alberta]]

Latest revision as of 22:27, 15 October 2024

System Specifications
FACP: Mircom FA-106
FACP Location: Lobby, Hall Side
System Type: Single-Stage Conventional
System Line Voltage: 120VAC
NAC Voltage: 24VFWR
System Coding: Temporal
Date of last known Upgrade: 2024
Year Opened: 1950s

Winfield Agriplex is a multi-use building located at 401 6 St E, Wetaskiwin County, AB. It consists of a hall and arena; it was originally built as the Winfield Arena (now Woody Johnson Arena) in the 1950s, and was expanded around 1986 to add the hall. The fire alarm system was upgraded around 1983 for the lobby and arena, the hall's bells are original; the fire alarm system was partially upgraded in 2024.

System Specifications (1980s-present)[edit | edit source]

FACP[edit | edit source]

The building is protected by a Mircom FA-106 conventional fire alarm system. The panel is located on the south the lobby near the hall, and is also noticeably mounted high. The system coding is temporal.

The FA-106 replaced an EST 6601 in 2024 after a panel failure.

Notification Appliances[edit | edit source]

Most notification appliances in the lobby and arena hallways are Chubb 960-1033 vibrating bells (10” gong). There is also one installed outdoors for exterior notification.

There are some Edwards 439D-10AWC vibrating bells (10" gong) in the same areas, installed during 1986.

There is a Mircom BL-10B motor bell (10" gong) in the arena as a deficiency replacement for an Edwards 439D-10AWC.

The hall portion has Edwards 439D-6AWC vibrating bells (6" gong).

Initiating Devices[edit | edit source]

Pull Stations[edit | edit source]

The lobby and arena mostly have Sentron 303 conventional single-action pull stations.
There are some Sentron 304 conventional two-stage pull stations, wired as single-stage.

The hall has Mircom MS-401 conventional single-action pull stations; these replaced Edwards 274-111 conventional single-action pull stations in 2024.

Automatic Detection Devices[edit | edit source]

There are Mircom 5601A conventional 135°F fixed-temperature/rate-of-rise heat detectors throughout the facility, installed in 2024.

These replaced Edwards 281C conventional 135°F fixed-temperature/rate-of-rise heat detectors throughout, with some Sentron 320 conventional 135°F fixed-temperature/rate-of-rise heat detectors.

EOLs[edit | edit source]

There are two Edwards EOL-P1 end-of-line resistor plates on all circuits.