HI Banff Alpine Centre

System Specifications
FACP: Notifier NFS-320C FACP Location: Main Entrance Vestibule System Type: Single-Stage Addressable System Line Voltage: 120VAC NAC Voltage: 24VDC System Coding: Temporal Strobes Synchronized: Yes, System Sensor Date of last known Upgrade: 2017 Year Opened: 1950s, 1986

HI Banff Alpine Centre is a hostel located at 801 Hidden Ridge Way, in Banff, Alberta, Canada. It consists of two buildings, the main building, built in the 1950s and renovated in 1986 as a hostel, and the Mary Belle Building, built in 1998. The main building's fire alarm system was upgraded in 2017, and the Mary Belle Building has the original fire alarm system.

System Specifications (Main Building) (2017-present)

FACP

The building is protected by a Notifier NFS-320C addressable fire alarm system. The panel is located in the main entrance vestibule. The system runs Notifier’s FlashScan addressable protocol, and the system coding is temporal.

Notification Appliances

All notification appliances are System Sensor “SpectrAlert Advance” P2RA horn/strobes (red, wall-mount).

Initiating Devices

Pull Stations

All pull stations are Notifier NBG-12LX addressable dual-action pull stations.

Automatic Detection Devices

There are Notifier FSP-851 addressable photoelectric smoke detectors in some areas.

There are Notifier FST-851RA addressable 135°F fixed-temperature/rate-of-rise heat detectors in the kitchens and storage areas.

All detectors are mounted on System Sensor B210LPA bases.

EOLs

There are Notifier EOL-CR end of line resistor plates on all signal circuits.

System Specifications (Main Building) (1986-2017)

System Specifications
FACP: Edwards 2280 FACP Location: Main Entrance Vestibule System Type: Single-Stage Conventional System Line Voltage: 120VAC NAC Voltage: 24VDC System Coding: Continuous Strobes Synchronized: No Date of last known Upgrade: 2015 Year Installed: 1986 Year Decommissioned: 2017

FACP

The building was protected by an Edwards 2280 conventional fire alarm system. The panel was located in the main entrance vestibule. The system coding was continuous.

Notification Appliances

Most notification appliances were Edwards "Durabel" 6100D vibrating bells (6" gong).

There was an Edwards 439D-6AWC vibrating bell (6" gong) on EST 403-5A-R strobe plate (15cd) in the Storm Cellar, installed in 2015.

Initiating Devices

Pull Stations

Most pull stations were Edwards 270-SPO conventional single-action pull stations.

There was an Edwards 274-111 conventional pull station in the Storm Cellar.

There were two Pyrene 950-1050 conventional pull stations at the entrance and common eating area as deficiency replacements.

Automatic Detection Devices

There were System Sensor "i3" C2W-BA conventional photoelectric smoke detectors in some areas, installed in 2015 replacing older unknown ionization smoke detectors.

There were Edwards 282A conventional rate-of-rise/197 degree fixed-temperature heat detectors in the kitchen and other areas.

There was a System Sensor 5601A conventional rate-of-rise/135 degree fixed-temperature heat detector in the Cougar Pete's as a deficiency replacement.

There was also an FDD CR135 135 degree fixed temperature/rate-of-rise heat detector in the Storm Cellar as a deficiency replacement.

System Specifications (Mary Belle Building) (1998-present)

System Specifications
FACP: Edwards EST2 FACP Location: Main Entrance Vestibule System Type: Single-Stage Addressable System Line Voltage: 120VAC NAC Voltage: 24VDC System Coding: Continuous Strobes Synchronized: No Date of last known Upgrade: 2016 Year Opened: 1998

FACP

The building is protected by an Edwards EST2 addressable fire alarm system. The panel is located in the main entrance vestibule. The system runs EST's Signature addressable protocol, and the system coding is continuous.

Notification Appliances

All common area audible notification appliances but one are Edwards 439D-6AWC vibrating bells (6" gong). Most are mounted on EST 403-5A-R strobe plates (15cd).

There is a Wheelock RSSP-24MCW strobe plate (red, set to 15cd) in the lobby as a deficiency replacement in 2016; the bell remains intact.

The guest rooms have EST 692-5A-HSR mini-horn/strobes (red, wall-mount, 15cd).

Initiating Devices

Pull Stations

All pull stations are EST SIGA-270 addressable single-action pull stations.

Automatic Detection Devices

There are EST SIGA-PS addressable photoelectric smoke detectors in some areas.

The rooms and kitchen have EST SIGA-HRS addressable 135°F fixed-temperature/rate-of-rise heat detectors.

All detectors are mounted on SIGA-SB bases.

EOLs

There are Edwards EOL-P1 end of line resistor plates on all Class-B signal circuits.