Miette Hot Springs

System Specifications
FACP: EST QuickStart QS4 FACP Location: Behind Front Desk System Type: Single-Stage Conventional System Line Voltage: 120VAC NAC Voltage: 24VFWR System Coding: Likely Temporal Date of last known Upgrade: 2010s Year Opened: 1986

Miette Hot Springs is a tourist attraction in Jasper National Park, AB. It is an outdoor hot pool with two pools. The building also has a restaurant, and a souvenir gift shop. The building was built in 1986, and the system was upgraded in 2007. Most of the notification appliances, one pull station and most smoke detectors are original.

System Specifications (1986-present)

FACP

The building is protected by an EST QuickStart QS4 conventional fire alarm system. The panel is located behind the front desk. The system coding is likely temporal.

The panel was installed in 2007, replacing an Edwards 2280.

Notification Appliances

All notification appliances except for one are Edwards 439D-6AWC vibrating bells (6" gong). These are original to the building.

There is a Notifier KMS-10-24A motor bell (10" gong) outside facing the pools as a deficiency replacement.

Initiating Devices

Pull Stations

All pull stations except for one are Mircom MS-401 conventional pull stations. Most were installed following the renovation, and there are a few newer variants as deficiency replacements.

There is one Edwards 270-SPOB conventional pull station by the staff room, which is likely original.

Automatic Detection Devices

There are System Sensor 1400A conventional ionization smoke detectors in some areas.

There is one System Sensor C2W-BA conventional photoelectric smoke detector as a deficiency replacement.

There are Edwards 281C conventional 135°F fixed-temperature/rate-of-rise heat detectors in some areas.

EOLs

There are Edwards EOL-P1 end of line resistor plates on all circuits.