Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

We have switched hosting. Sorry for the recent downtime. :)

Miette Hot Springs: Difference between revisions

From FireAlarmPedia
(This is me being a dumbass once again. Panel is a QS4 - no wonder it was conventional!)
Line 20: Line 20:
All pull stations except for one are Mircom MS-401 conventional pull stations. Most were installed following the renovation, and there are a few newer variants as deficiency replacements. There is one Edwards 270-SPOB conventional pull station by the staff room, which is likely original.
All pull stations except for one are Mircom MS-401 conventional pull stations. Most were installed following the renovation, and there are a few newer variants as deficiency replacements. There is one Edwards 270-SPOB conventional pull station by the staff room, which is likely original.
==== Automatic Detection Devices ====
==== Automatic Detection Devices ====
The smoke detectors are mainly Edwards EDW1451A ionization smoke detectors. One of them was replaced with a System Sensor C2W-BA i3 photoelectric smoke detector. The heat detectors are are Edwards 281B-PL.
Most smoke detectors are System Sensor 1412B direct-wire ionization smoke detectors. There is one Mircom "i3" 2W-BA photoelectric smoke detector as a deficiency replacement. The heat detectors are Edwards 281C fixed-temp/rate-of-rise heat detectors, which have likely been replaced as they were recalled in 2020.
Most smoke detectors are System Sensor 1412B direct-wire ionization smoke detectors. There is one Mircom "i3" 2W-BA photoelectric smoke detector as a deficiency replacement. The heat detectors are Edwards 281C fixed-temp/rate-of-rise heat detectors, which have likely been replaced as they were recalled in 2020.
[[Category:Facilities]]
[[Category:Facilities]]
[[Category:Facilities]]
[[Category:Facilities]]

Revision as of 15:37, 26 November 2023

System Specifications
FACP: EST QuickStart QS4

FACP Location: Behind Front Desk
System Type: Conventional
System Line Voltage: 120VAC
NAC Voltage: 24VFWR

System Coding: Likely Temporal
Date of last known Upgrade: 2010s
Year Opened: 1986

Miette Hot Springs is a tourist attraction in Jasper National Park, AB. It is an outdoor hot pool with two pools. The building also has a restaurant, and a souvenir gift shop. The building was built in 1986, and most of the notification appliances, one pull station and most smoke detectors are original.

System Specifications

FACP

The building is protected by an EST QuickStart QS4 conventional fire alarm system. The panel is located behind the front desk, and replaced an Edwards 2280 in 2007 following a renovation. The system coding is likely temporal.

Notification Appliances

All notification appliances except for one are Edwards 439D-6AWC vibrating bells (6" gong). These are original to the building. There is a Notifier KMS-10-24A motor bell (10" gong) outside facing the pools as a deficiency replacement.

Initiating Devices

Pull Stations

All pull stations except for one are Mircom MS-401 conventional pull stations. Most were installed following the renovation, and there are a few newer variants as deficiency replacements. There is one Edwards 270-SPOB conventional pull station by the staff room, which is likely original.

Automatic Detection Devices

Most smoke detectors are System Sensor 1412B direct-wire ionization smoke detectors. There is one Mircom "i3" 2W-BA photoelectric smoke detector as a deficiency replacement. The heat detectors are Edwards 281C fixed-temp/rate-of-rise heat detectors, which have likely been replaced as they were recalled in 2020.