Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

We have switched hosting. Sorry for the recent downtime. :)

TwentyThree33's Basement: Difference between revisions

From FireAlarmPedia
(Complete system overhaul occurred last week.)
Line 15: Line 15:
*Note: YYCsFireAlarmNimrod frequently modifies the fire alarm system, hence the "can range from" and "usually consist" parts. He is currently receiving about 30 new parts, which will be used on the system. Although he frequently modifies it, it is always powered up. He can pull the alarm on it any time he wants to without being fined as it is a controlled environment. NEVER pull a fire alarm unless there is actually a fire emergency.
*Note: YYCsFireAlarmNimrod frequently modifies the fire alarm system, hence the "can range from" and "usually consist" parts. He is currently receiving about 30 new parts, which will be used on the system. Although he frequently modifies it, it is always powered up. He can pull the alarm on it any time he wants to without being fined as it is a controlled environment. NEVER pull a fire alarm unless there is actually a fire emergency.
==== FACP ====
==== FACP ====
There are currently two fire alarm panels in this basement. The main fire panel is a Simplex 4010. It came from CJ9899, and controls all notification appliances, three pull stations, and some smoke detectors. It came from Youtuber CJ9899, and was previously owned by MRIDNETGUY2004, and Zachary Fleck. The 4010 was manufactured in 2008. The other panel is the original panel to this basement, a Fire-Lite MS-4. It came from Aden Knowler, and was previously owned by [[User:Twentytwo22]]. It was previously used in the [[Barndominium]]. It is set up at a table, and is used for testing other devices. It is tied into the 4010, and, when in alarm, causes a supervisory on the 4010. The MS-4 has a charger fault, caused by someone reversing the polarity on the batteries. This was not caused by the current owner. The MS-4 was made in December 2015.
The current FACP in this basement is a Notifier AFP-200C addressable fire alarm panel. It was made in 2003, and was previously in use at [[40 Sunpark Plaza SE]]. The panel was removed due to NAC troubles, but the culprit was found to have been bent prongs on the horn/strobe terminals. This panel is in immaculate condition, and is fully functional, with no troubles or any other issues. When in alarm, the system does march time.
==== Notification Appliances ====
==== Notification Appliances ====
The notification appliances usually consist of a Simplex 2901-9720 (made in 1988) 6 inch motor bell and an EST "Integrity" 202-5A-T remote strobe (made in 1997) The 2901-9720 came out of [[R.T. Alderman School]], and the strobe came out of a Walmart in Cambridge, Ontario. More notification appliances used are an Edwards 892-2B (made in 1992) with only the strobe hooked up (the horn failed), EST "Integrity" 757-5A-T horn/strobes (also made in 1997), and recently a Simplex 2901-9722 motor bell, and an EST "Genesis LED" G1-AVRF (red, wall mount, FIRE marking) horn/strobe. The 2901-9722 also came out of [[R.T. Alderman School]]. The Genesis LED horn/strobe came from [[User:Twentytwo22]]. Other notification appliances used include a Simplex "TrueAlert" 4906-9102 (red, ceiling, SmartSync) remote strobe that came new in box, an EST "Integrity" 757-7A-T (red, 15/75 cd) horn/strobe, and two more Simplex 2901-9720 motor bells.  The Integrity devices, the two additional 2901-9720s, and the TrueAlert strobe all came from YouTuber CJ9899.
The notification appliances are currently a Simplex 2901-9720 motor bell (6"), along with the following devices being wired as strobes: Gentex GEC3-24WR, Edwards 757-5A-T, EST G1AVRF, System Sensor SRA, Edwards 202-5A-T, Edwards 757-7A-T, and Edwards 892-2B.
 
=== Initiating Devices ===
=== Initiating Devices ===
==== Pull Stations ====
==== Pull Stations ====
The pull stations are also changed out sometimes, but they consist of a Simplex 2099-9201 (4251-20), a Simplex 2099-9754, an ADT B5009, an FCI MS-2, but an "EPO & DISCONNECT" variant, which is meant for an emergency stop switch, a Fire-Lite BG-12L, and a GE 270-SPO. The Simplex 2099-9201 came out of [[R.T. Alderman School]], and the GE 270-SPO was from [[User:Twentytwo22]]. Other pull stations include two 1990s Edwards 270-SPO pull stations, a rare variant Edwards 270-SPO pull station, along with a first generation 270-SPO, an Edwards 275-C111 pull station, a Mircom MS-401 pull station, seven Mirtone 73303 pull stations, and an Edwards 270-GAO two-stage pull station. Other pull stations used are a Mirtone 73201, and a French-only 2nd generation Edwards 270-SPO. He also owns a Simplex 4099-9004 addressable single-action pull station, and two Simplex 4099-9004CB (bilingual, LED light) addressable single-action pull stationsOne 1990s 270-SPO, the 275-C111, 3 of the Mirtone 73303s, the MS-401, and the 4099-9004 all came from Canadian Alarms, and the other 1990s 270-SPO, the 270-GAO, the one remaining 73303, and the 4099-9004CBs all came from CJ9899.
The pull stations currently consist of a Notifier N-MPS-SA, a Notifier NBG-12LX, two Notifier LNG-1Rs (one wired as supervisory for strobes), and a Mirtone 73201 (wired as a silence switch). The LNG-1R pull stations are wired into Notifier FMM-101A addressable modules, and the 73201 is wired into a Notifier FMM-1A full-size addressable module.  These were chosen in favor of the MMX-101 modules he has due to FlashScan capabilities in case the panel is upgraded.
==== Automatic Detection Devices ====
There is currently only one detector on this system. It is a Notifier FSL-751A VIEW (Very Intelligent Early Warning) laser smoke detectorIt was removed from the Enmax headquarters in Calgary.


==== Automatic Detection Devices ====
Fun fact: The JCI tech known as Vic said to Yycsfirealarmnimrod that this detector "belonged to the garbage can". Naturally, Yycsfirealarmnimrod put the detector in his backpack before anyone noticed.
The automatic detection devices are a Simplex 2098-9110 2-wire ionization smoke detector, an Edwards C2M-PD photoelectric smoke detector, a System Sensor 5601A rate-of-rise/fixed temp heat detector, a System Sensor "i3" C2W-BA photoelectric smoke detector, an Edwards 6249C ionization smoke detector, and an Edwards 281B-PL rate-of-rise/fixed temperature heat detector. The 2098-9110 was used previously, it came out of [[R.T. Alderman School]]. Addressable detectors are a Simplex 4098-9714 photoelectric addressable smoke detector, and a Simplex 4098-9734 addressable rate-of-rise heat detector.
== Videos ==
== Videos ==
Videos of this system will be uploaded on his channel: https://www.youtube.com/c/ExistentCanadianObject <br>
Videos of this system will be uploaded on his channel: https://www.youtube.com/c/ExistentCanadianObject <br>
Fire alarm going off for a test: https://www.youtube.com/watch?v=lVfJF4ezMEM
Fire alarm going off for a test: https://www.youtube.com/watch?v=lVfJF4ezMEM

Revision as of 14:09, 9 November 2021

System Specifications
FACP: Simplex 4010
System Line Voltage: 120VAC
NAC Voltage: 24VDC

System Type: Addressable (Hybrid Manner)
Date of last upgrade: 2021
Year Built: 2003

NOTE: This page is being heavily edited due to a panel change in this fire alarm system. It is also updated every time he gets a new fire alarm device.

YYCsFireAlarmNimrod's Basement (name may be subject to change) is a basement in Calgary, built in 2003. It has a mini fire alarm system owned and serviced by User:YYCsFireAlarmNimrod.

System Specifications

  • Note: YYCsFireAlarmNimrod frequently modifies the fire alarm system, hence the "can range from" and "usually consist" parts. He is currently receiving about 30 new parts, which will be used on the system. Although he frequently modifies it, it is always powered up. He can pull the alarm on it any time he wants to without being fined as it is a controlled environment. NEVER pull a fire alarm unless there is actually a fire emergency.

FACP

The current FACP in this basement is a Notifier AFP-200C addressable fire alarm panel. It was made in 2003, and was previously in use at 40 Sunpark Plaza SE. The panel was removed due to NAC troubles, but the culprit was found to have been bent prongs on the horn/strobe terminals. This panel is in immaculate condition, and is fully functional, with no troubles or any other issues. When in alarm, the system does march time.

Notification Appliances

The notification appliances are currently a Simplex 2901-9720 motor bell (6"), along with the following devices being wired as strobes: Gentex GEC3-24WR, Edwards 757-5A-T, EST G1AVRF, System Sensor SRA, Edwards 202-5A-T, Edwards 757-7A-T, and Edwards 892-2B.

Initiating Devices

Pull Stations

The pull stations currently consist of a Notifier N-MPS-SA, a Notifier NBG-12LX, two Notifier LNG-1Rs (one wired as supervisory for strobes), and a Mirtone 73201 (wired as a silence switch). The LNG-1R pull stations are wired into Notifier FMM-101A addressable modules, and the 73201 is wired into a Notifier FMM-1A full-size addressable module. These were chosen in favor of the MMX-101 modules he has due to FlashScan capabilities in case the panel is upgraded.

Automatic Detection Devices

There is currently only one detector on this system. It is a Notifier FSL-751A VIEW (Very Intelligent Early Warning) laser smoke detector. It was removed from the Enmax headquarters in Calgary.

Fun fact: The JCI tech known as Vic said to Yycsfirealarmnimrod that this detector "belonged to the garbage can". Naturally, Yycsfirealarmnimrod put the detector in his backpack before anyone noticed.

Videos

Videos of this system will be uploaded on his channel: https://www.youtube.com/c/ExistentCanadianObject
Fire alarm going off for a test: https://www.youtube.com/watch?v=lVfJF4ezMEM