8327 48 Avenue Garage: Difference between revisions

Revision as of 19:08, 26 March 2022

8327 48 Avenue Garage is a small residential garage in Calgary, built in 1975. The system is currently owned by User:AdenK2333.

System Specifications

FACP

The fire alarm panel is a Mircom FA-102T. When the system is in ALARM, the coding is on continuous NAC 1.

Notification Appliances

The notification appliances consist of two System Sensor P2RA horn/strobes (2-wire, red, wall mount) set on TEMP3 LOW, 15 cd and a System Sensor PC2RA (2-wire, red, wall mount) set on TEMP3 LOW, 15 cd.

Initiating Devices

Pull Stations

The pull stations consists of two Mircom MS-401 pull stations (conventional, single action, screw terminals).

Automatic Detection Devices

There is no automatic detection devices installed in the system.

@@ Line 1: / Line 1: @@
 48 Avenue Garage is a small residential garage in Calgary, built in 1975. The system is currently owned by [[User:AdenK2333]].
-*'''NOTE''': Due to a dispute between the owners and this user, this page is no longer supported. However, it will remain up for historical purposes.
 == System Specifications ==
 ==== FACP ====
-The fire alarm panel is an ADT Unimode 10UD-7. Most of the zones are unused and simply have a resistor across them due to the small size of the garage. When the system is in ALARM, the coding is on March Time for NAC 1 (horn) and Wheelock Sync for NAC 2 (strobe). NAC 2 is non-silencable, so that means when the system is silenced, the strobe continues to flash until the system is reset.
+The fire alarm panel is a Mircom FA-102T. When the system is in ALARM, the coding is on continuous NAC 1.
 ==== Notification Appliances ====
-The only notification appliance is a Wheelock MT-241575W-FR (15/75cd) multi-tone horn/strobe (red, wall mount) set on bell, but does march time due to panel coding.
+The notification appliances consist of two System Sensor P2RA horn/strobes (2-wire, red, wall mount) set on TEMP3 LOW, 15 cd and a System Sensor PC2RA (2-wire, red, wall mount) set on TEMP3 LOW, 15 cd.
 === Initiating Devices ===
 ==== Pull Stations ====
-The pull stations consists of two Edwards 278B-1120 pull stations (conventional, dual action, key lock, screw terminals). The pull stations were previously installed in the [[Barndominium]].
+The pull stations consists of two Mircom MS-401 pull stations (conventional, single action, screw terminals).
 ==== Automatic Detection Devices ====
-There is one automatic detection device, a System Sensor C2WTA-BA, 2-wire, photoelectric i3 smoke detector with a thermal sensor and a built-in sounder. The sounder was removed due to it being unneccesary and annoying. Freeze supervision for this zone is disabled due to the garage ambient temperature falls below freezing during the winter months. The smoke detector was previously installed in the [[Barndominium]].
+There is no automatic detection devices installed in the system.
 [[Category:Facilities]]