More actions
No edit summary |
|||
| Line 50: | Line 50: | ||
None, as codes did not require detectors at that time. | None, as codes did not require detectors at that time. | ||
[[] | [[] | ||
[[Category:Calgary]] | |||
[[Category:Retail Stores]] | |||
[[Category:Iconic buildings in Calgary]] | |||
Revision as of 18:10, 18 May 2024
| System Specifications |
|---|
| FACP: Notifier NFS-320C
FACP Location Unknown System Coding: Temporal Strobes Synchronized: Yes, SS |
7520 Macleod Trail SE is the address of a building in the Fairview Industrial area of Southeast Calgary. It was built in 1975 as Lloyd’s Recreation Centre, a roller rink. However, due to a lack of patronage, the rink closed in 2017, and was converted into Visions Electronics. The current system was installed in 2018, following the conversion of the building. This page will showcase both the current and previous systems.
System Specifications (2018-present)
NOTE: This system is unconfirmed, and is based on typical Notifier systems from this time.
FACP
The building is protected by a Notifier NFS-320C addressable fire alarm system. The panel location is unknown, and was installed in 2018. The system runs Notifier's FlashScan addressable protocol, and the system coding is temporal.
Notification Appliances
All notification appliances are System Sensor “L Series” P2RLA horn/strobes (red, wall-mount, bilingual lettering, set to 15cd, electromechanical)
Initiating Devices
Pull Stations
The pull stations are likely Notifier NBG-12LX addressable dual-action pull stations.
Automatic Detection Devices
There is a sprinkler system with waterflow detection, so there are no visible detectors.
Modules
There are Notifier FMM-1A addressable monitor modules supervising the sprinkler system's tamper and flow switches.
Original System Specifications (Lloyd’s) (1975-2017)
| System Specifications |
|---|
| FACP: Edwards Custom 6500
FACP Location: Main Office? System Coding: Continuous |
FACP
The building was protected by the original Edwards Custom 6500 conventional fire alarm system. The panel was likely located in the main office, the system coding was likely continuous.
The system lasted a mere 42 years before being replaced, with no upgrades.
Notification Appliances
The notification appliances were Edwards “Durabel” 6100D vibrating bells (6” gong).
Initiating Devices
Pull Stations
All pull stations were third-generation Edwards 270-SPO single-action pull stations.
Automatic Detection Devices
None, as codes did not require detectors at that time. [[]