Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

We have switched hosting. Sorry for the recent downtime. :)

5675 Signal Hill Centre SW, Calgary

From FireAlarmPedia
Revision as of 09:48, 7 September 2024 by TwentyThree33 (talk | contribs) (Added EOLs, cleaned up page including infobox updates.)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
System Specifications
FACP: Notifier AFP-200
FACP Location: Main Electrical Room
System Type: Single-Stage Addressable
System Line Voltage: 120VAC
NAC Voltage: 24VDC
System Coding: Continuous
Strobes Synchronized: No
Date of last known Upgrade: 2020s
Year Opened: 1998

5675 Signal Hill Centre SW, Calgary is the address given to a commercial shopping plaza in the Signal Hill/Westhills shopping district of Calgary, Alberta, Canada. The plaza consists of Value Buds, The Bro’Kin Yolk, F45, Pho Pham, Visions Electronics, Eddie Bauer, Structube, The Shoe Company, La Vie en Rose, PetValu, Achieve Wellness Spa, and The Brick. The plaza was built in 1998, and the fire alarm system is original, with parts replaced as deficiencies occur.

System Specifications (1998-present)

FACP

The building is protected by a Notifier AFP-200 addressable fire alarm system. The panel is located in an electrical room at the rear of the building. The system runs Notifier’s CLIP addressable protocol, and the system coding is likely continuous.

Notification Appliances

Most notification appliances are Wheelock MB-G10-24 motor bells (10” gong) mounted on Wheelock RSSP-2415W strobe plates (red, 15cd). One is mounted on the ceiling in Visions.
There is a Mircom BL-10B motor bell (10” gong) in Visions on the original strobe plate as a deficiency replacement.
There are Notifier KMS-10-24A motor bells (10” gong) mounted on Wheelock RSSP-24MCW strobe plates (red, set to 15cd) in the Bro’Kin Yolk, installed in 2015.
For exterior notification, there is a System Sensor “SpectrAlert Advance” SRKA weatherproof remote strobe (red, wall-mount, set to 75cd) at the rear of the building.

Initiating Devices

Pull Stations

Most pull stations are Notifier NFM-950B conventional single-action pull stations, wired to Notifier MMX-101A addressable monitor modules
There is a Mircom MS-401 conventional pull station in Structube as a deficiency replacement, wired to a Notifier FMM-101A addressable monitor module.
There are Notifier NBG-12LX addressable dual-action pull stations in The Bro’Kin Yolk, installed in 2015.

Automatic Detection Devices

None noticed.

Modules

There are Notifier MMX-1A addressable monitor modules supervising the sprinkler system’s tamper and flow switches.

EOLs

There are Notifier EOL-CR end of line resistor plates on all sprinkler and signal circuits.