Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

We have switched hosting. Sorry for the recent downtime. :)

Sunridge Mall

From FireAlarmPedia
Revision as of 00:13, 14 October 2024 by Alberta Fire Alarms (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
System Specifications
FACP: Siemens FireFinder XLS

FACP Location: Multiple
System Type: Two Stage Networked Addressable
System Line Voltage: 120VAC
NAC Voltage: 70.7VRMS (audible)
24VDC (visuals)

System Coding: 20BPM (alert)

Temporal 1kHz + female message (Alarm)

Strobes Synchronized: Yes
Date of last known Upgrade: 2019
Year Opened: 1981, 2005

Sunridge Mall is a shopping centre located at 2525 36 St NE in the Sunridge neighborhood of Northeast Calgary. It was built in 1981, and underwent a large renovation in 2005. The fire alarm system was installed in 2014.

System Specifications

FACP

The mall is protected by a networked Siemens FireFinder XLS addressable fire alarm system. This has been confirmed from the numerous annunciators, but the panels are not visible. The panels have voice-evac capabilities. The system runs Siemens' FirePrint addressable protocol, and is configured for two-stage operation. The system's alert signal is 20BPM, and a 1kHz temporal tone and a female message in general alarm.

Annunciators

There are Siemens SSD annunciators located at every exit.

Notification Appliances

There is a wide variety of speaker/strobes located throughout the mall. Most are Siemens SE-MC-CW-B speaker/strobes (bilingual, white, ceiling-mount, rebranded Wheelock E60-24MCC-FW), installed in 2014. The new wing has Siemens SE-MC-W-B speaker/strobes (bilingual, white, wall-mount), installed in 2019.

Initiating Devices

Pull Stations

The pull stations are Siemens HMS-2S bilingual two-stage pull stations.

Automatic Detection Devices

There are Siemens "FirePrint" FP-11 addressable multisensor smoke/heat combo detectors throughout the mall.

Modules

There are Siemens XTRI-M addressable monitor modules supervising the sprinkler system's tamper and flow switches.

EOLs

There are Siemens EL-300C end-of-line resistor plates on all sprinkler and signal circuits.

System Specifications (2005-2014)

System Specifications
FACP: Edwards EST3

FACP Location: Multiple
System Type: Two-Stage Networked Addressable
System Line Voltage: 120VAC
NAC Voltage: 24VDC

System Coding: 20BPM (Alert) Temporal (Alarm)

Strobes Synchronized: Yes
Date of last known Upgrade: N/A

Year Installed: 2005
Year Decommissioned: 2014

Note: This system is based off of YouTube videos and recollection from a technician, so it may not be 100% accurate.

FACP

The mall was protected by an Edwards EST3 addressable fire alarm system. The age of this system was unknown. The system ran EST's Signature addressable protocol, and was configured for two-stage operation. Alert signal coding was 20BPM, followed by temporal in general alarm.

Notification Appliances

All notification appliances were EST "Integrity" 757-5A-T horn/strobes (red, wall-mount, 15cd).

Initiating Devices

Pull Stations

All pull stations were EST SIGA-270P addressable two-stage single-action pull stations.

Automatic Detection Devices

There were EST SIGA-PS addressable photoelectric smoke detectors throughout the mall, mounted on SIGA-SB bases.

Modules

There were EST SIGA-CT1 addressable monitor modules supervising the sprinkler system's tamper and flow switches.

EOLs

There were Edwards EOL-P1 end-of-line resistor plates on all sprinkler and signal circuits.