More actions
| System Specifications |
|---|
| FACP: Edwards EST3 FACP Location: Unknown System Type: Addressable System Line Voltage: 120VAC NAC Voltage: 24VDC System Coding: 20BPM (First Stage) Temporal (GA) Strobes Synchronized Date of last known Upgrade: Currently being upgraded Year Opened: 1981 |
The BMO Centre is a large convention centre located at 20 Roundup Way SE, Calgary, AB. It is located on the grounds of Stampede Park. The building hosts many events, such as car shows and other expos. The building originally opened in 1981, and was expanded in 2009. The building is currently undergoing a massive expansion, which caused Hall A to be demolished. The fire alarm system was upgraded around 2003, and is currently undergoing an upgrade.
Note: This page is accurate to July 2022, and does not contain any information on the system for the expansion. This page should not be used for official purposes.
Former System Specifications (1981 building) (2003-2023)
| Former System Specifications |
|---|
| FACP: Edwards EST3 FACP Location: Unknown System Type: Two-Stage Addressable System Line Voltage: 120VAC NAC Voltage: 24VDC System Coding: 20BPM (Alert) Temporal (Alarm) Strobes Synchronized: Yes, EST Date of last known Upgrade: 2018 Year Installed: 2003 Year Decommissioned: 2023 |
FACP
The building was protected by an Edwards EST3 addressable fire alarm system. The panel location was unknown. The system ran EST’s Signature addressable protocol, and was configured for two-stage operation. The alert signal coding is 20BPM in first stage, followed by temporal in alarm
The EST3 was installed in 2013, replacing an Edwards EST2 that was water-damaged from the floods.
Annunciators
There was an Edwards EST3-LCDANN annunciator in the now-demolished Hall A entrance vestibule.
Notification Appliances
Most notification appliances were Edwards MB10-24 motor bells (10” gong) mounted on Edwards 403-5A-R strobe plates (15cd).
One showroom, as well as one corridor contained Edwards 439D-10AWC vibrating bells (10” gong) on a 403-5A-R strobe plates (15cd), leftover from the EST2, which were most likely installed in 2000.
There was one Edwards 439D-10AWC vibrating bell (10” gong, white label) by an entrance as a deficiency replacement in 2018; the strobe plate remained, this particular one was near Hall A and no longer exists.
There was an Edwards 439D-10AWC vibrating bell (10” gong) outside the building.
Initiating Devices
Pull Stations
Most pull stations were EST SIGA-270P addressable two-stage single-action pull stations; most were installed in 2003. Deficiency replacements of all generations could be found scattered.
One showroom contained first-generation SIGA-270P pull stations (shield logo, 2000)
There were a couple of original Edwards 270-GAO conventional two-stage pull stations, these were likely wired to SIGA-CT2 dual-input monitor modules.
Automatic Detection Devices
There were EST SIGA-PS addressable photoelectric smoke detectors in some areas, mounted on SIGA-SB bases. There was also a sprinkler system with waterflow detection.
Modules
There were EST SIGA-CT1 addressable monitor modules supervising the sprinkler system's tamper and flow switches.
Accessories
There was an Edwards EBP6SA 6.5A booster panel located beside the 3-LCDANN, as there was an EST2 panel in its place prior to the floods.
EOLs
There were Edwards EOL-P1 end-of-line resistor plates on all sprinkler and signal circuits.
| System Specifications |
|---|
| FACP: Edwards EST3X FACP Location: Northwest Entrance Vestibule System Type: Addressable System Line Voltage: 120VAC NAC Voltage: 24VDC System Coding: 20BPM (First Stage) Temporal (GA) Strobes Synchronized Date of last known Upgrade: 2016 Year Opened: 2009 |
System Specifications (2009 Expansion) (2009-persent)
FACP
The building is protected by an Edwards EST3X addressable fire alarm system. The panel is located in the northwest entrance vestibule. The system runs EST’s Signature addressable protocol, and is configured for two-stage operation. The system coding is 20BPM in first-stage, followed by temporal in general alarm.
Notification Appliances
All notification appliances are Edwards 439D-10AWC vibrating bells (10” gong) on Edwards 403-5A-R strobe plates (15cd).
Initiating Devices
Pull Stations
All pull stations are EST SIGA-270P addressable two-stage single-action pull stations.
Automatic Detection Devices
None noticed. There is a sprinkler system with waterflow detection.
Modules
There are EST SIGA-CT1 addressable monitor modules supervising the sprinkler system's tamper and flow switches.