Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

We have switched hosting. Sorry for the recent downtime. :)

40 Sunpark Plaza SE

From FireAlarmPedia
Revision as of 08:25, 14 October 2021 by TwentyThree33 (talk | contribs) (Fucked up a header.)
System Specifications
FACP: Notifier NFS-320C
System Type:Addressable
System Line Voltage: 120VAC
NAC Voltage:24VDC
Date of last known Upgrade: 2020
Year Opened: 2004

40 Sunpark Plaza SE is a mixed-use 3-story office complex located in the Sundance neighborhood of SE Calgary. The first floor contains a doctor's office, a Shoppers Drug Mart, and formerly an optometrist. It was built in 2004, but received a system overhaul in 2020.

System Specifications

FACP

The building is protected by a Notifier NFS-320C addressable fire alarm system. The panel is located at the main entrance. This system runs on Notifier's FlashScan addressable protocol. The panel is set to continuous, but the notification appliances are self-coded to code 3.

Notification Appliances

All notification appliances are from System Sensor's "L Series" line of products. The hallways, offices, and most other areas have System Sensor P2RLA horn/strobes (red, wall-mount, bilingual). Other areas have System Sensor SRLA remote strobes. The strobes are set to 15 candela, and the horns are set to code 3 electromechanical. All strobes are synchronized .

Initiating Devices

Pull Stations

All pull stations are Notifier NBG-12LX addressable dual-action pull stations.

Automatic Detection Devices

There are Notifier FSP-851A addressable photoelectric smoke detectors located throughout the facility.

System Specifications (original system)

FACP

The original fire alarm panel was a Notifier AFP-200. It was removed in 2020 due to a potential NAC failure. However, the culprit was found to be bent prongs on the P2RA horn/strobes. Because it still worked, the AFP-200 was used as a demonstration panel for Viking Fire Protection until 2021. It was rescued by Yycsfirealarmnimrod, and is now his main panel. This system ran on Notifier's CLIP protocol.

Notification Appliances

The notification appliances were System Sensor "SpectrAlert Advance" P2RA horn/strobes (red, wall-mount). They replaced System Sensor "SpectrAlert" P1224MCA horn/strobes sometime in the late 2010s. There was also a Mircom "Select-A-Horn" FHS-340R in the atrium, which got replaced as well.

Initiating Devices

Pull Stations

The pull stations were Notifier MPS-950B conventional "tab" pull stations. As these were conventional, they had Notifier MMX-101A addressable modules tied into them.

Automatic Detection Devices

There were Notifier FSP-851 addressable photoelectric smoke detectors located throughout the building, which were not original. These are likely still in use on the new system.