Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

We have switched hosting. Sorry for the recent downtime. :)

Eau Claire Market

From FireAlarmPedia
Revision as of 20:36, 25 September 2024 by TwentyThree33 (talk | contribs)
System Specifications
FACP: Notifier NFS2-3030C
FACP Location: Parkade Electrical Room
System Type: Single-Stage Addressable
System Line Voltage: 120VAC
NAC Voltage: 24VDC
System Coding: Temporal
Date of last known Upgrade: 2023
Year Opened: 1993

Eau Claire Market was an indoor shopping mall located at 200 Barclay Parade SW, Calgary, Alberta, Canada. The mall opened in 1993, and closed in 2024. The fire alarm system was mostly original.

Former System Specifications (1993-2024)

FACP

The building was protected by a Notifier NFS2-3030C addressable fire alarm system. The panel was located in the parkade electrical room. The system ran Notifier’s CLIP addressable protocol, and the system coding is likely temporal.

The NFS2-3030C replaced a Notifier AM2020 in March 2023; this panel lasted 30 years in service!

Annunciators

There were Notifier LCD-160 annunciators in most entrance vestibules.

Notification Appliances

All notification appliances but one were Notifier KMS-10-24VDC/P motor bells (10” gong).

There was a Mircom BL-10A motor bell (10” gong) in Canadian Blood services as a deficiency replacement.

Initiating Devices

Pull Stations

Most pull stations were Notifier NFM-950B conventional single-action pull stations.

Some areas had Notifier MPS-950B conventional single-action pull stations and Mircom MS-401 conventional pull stations, both as deficiency replacements.

All stations were wired to Notifier MMX-101A addressable monitor modules, located directly behind each station.

Automatic Detection Devices

There were Notifier CPX-551A addressable ionization smoke detectors throughout the building, mounted on Notifier BX501 bases.

Some areas had Notifier FSP-851A addressable photoelectric smoke detectors as deficiency replacements, mounted on System Sensor B210LPA and B710LPA low-profile bases.

Modules

There were Notifier MMX-1A addressable monitor modules supervising the sprinkler system's tamper and flow switches.

There were Notifier CMX-2A addressable relay modules serving various purposes.

EOLs

There were Notifier EOL-CR end of line resistor plates on all sprinkler and signal circuits.