Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

We have switched hosting. Sorry for the recent downtime. :)

Shelbourne Place

From FireAlarmPedia
Revision as of 22:06, 12 October 2024 by Alberta Fire Alarms (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
System Specifications
FACP: Notifier NFS-320C
FACP Location: North Entrance
System Type: Single-Stage Conventional
System Line Voltage: 120VAC
NAC Voltage: 24VDC
System Coding: Continuous
Strobes Synchronized: N/A
Date of last known Upgrade: 2010s
Year Opened: 1978

Shelbourne Place is a small mixed-use building located at 1013 17 Avenue Southwest, in Calgary, Alberta, Canada. The building opened in 1978, and the fire alarm system has been upgraded over the years.

System Specifications[edit | edit source]

FACP[edit | edit source]

The building is protected by a Notifier NFS-320C conventional fire alarm system. The panel is located at the front entrance. The system has zone cards to accommodate the conventional devices on the system, and the system coding is continuous.

Notification Appliances[edit | edit source]

Most notification appliances are Edwards 439D-6AWC vibrating bells (6” gong).

Some areas have Notifier KMS-6-24A motor bells (6” gong) as deficiency replacements.

Initiating Devices[edit | edit source]

Pull Stations[edit | edit source]

Most pull stations are Edwards 270-SPO conventional single-action pull stations.

Some areas have Notifier MPS-950B conventional single-action pull stations as deficiency replacements.

Automatic Detection Devices[edit | edit source]

There are Edwards EC30U-3 conventional photoelectric smoke detectors at the top of each stairwell.

There are FDD CR-135 conventional 135 degree fixed/rate-of-rise heat detectors throughout, and System Sensor 5601A conventional fixed/rate-of-rise heat detectors in some areas. The building is not equipped with a sprinkler system.

EOLs[edit | edit source]

There are Edwards EOL-P1 end-of-line resistor plates on all circuits.