Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

We have switched hosting. Sorry for the recent downtime. :)

The Home Depot (Shawnessy)

From FireAlarmPedia
Revision as of 13:01, 14 October 2024 by Alberta Fire Alarms (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
System Specifications
FACP: Notifier NFS-320C

FACP Location: Unknown
System Type: Single-Stage Addressable
System Line Voltage: 120VAC
NAC Voltage: 24VDC

System Coding: Temporal

Strobes Synchronized: No
Date of last known Upgrade: Early 2010s
Year Opened: 1998

The Home Depot is an American hardware store franchise, with locations all over North America. This particular store is located at 390 Shawville Boulevard Southeast, in Calgary, Alberta, Canada. The store opened in 1998, and the fire alarm system is partially original.

System Specifications (1998-present)[edit | edit source]

FACP[edit | edit source]

The store is protected by a Notifier NFS-320C addressable fire alarm system. The panel location is unknown, and most likely replaced an AFP-200C. The system runs Notifier's CLIP addressable protocol, and the system coding is temporal.

Annunciators[edit | edit source]

There is a Notifier ACM-24AT annunciator in the main entrance vestibule.

Notification Appliances[edit | edit source]

Most notification appliances are System Sensor "SpectrAlert" P2415A horn/strobes (red, wall-mount, 15cd).

The restrooms have System Sensor S2415A remote strobes (red, wall-mount, 15cd).

Some areas have Mircom "Select-A-Horn/Strobe" FHS-240R horn/strobes (red, wall-mount, 15cd) as deficiency replacements.

Initiating Devices[edit | edit source]

Pull Stations[edit | edit source]

Most pull stations are Notifier MPS-950B conventional single-action pull stations.

There is a Simplex MS-301C conventional single-action pull station in the exit vestibule, and a Tyco/Grinnell MS-401GR conventional single-action pull station by an emergency exit, both installed as deficiency replacements.

Each pull station is wired to a Notifier MMX-101A addressable monitor module, located directly behind each station.

Automatic Detection Devices[edit | edit source]

None noticed, likely due to high ceilings. There is a sprinkler system with waterflow detection

Modules[edit | edit source]

There are Notifier MMX-1A addressable monitor modules supervising the sprinkler system's tamper and flow switches.

EOLs[edit | edit source]

There are Notifier EOL-CR end-of-line resistor plates on all sprinkler and signal circuits.