Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

We have switched hosting. Sorry for the recent downtime. :)

Vogue (Condo Building)

From FireAlarmPedia
Revision as of 17:11, 14 October 2024 by Alberta Fire Alarms (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
System Specifications
FACP: Mircom FX-2000

FACP Location: Main Floor Boiler Room

System Type: Single-Stage Addressable

System Line Voltage: 120VAC

NAC Voltage: 24VFWR

System Coding: Temporal

Strobes Synchronized: NO!

Date of last known Upgrade: 2010s

Year Opened: 2005

Vogue is a 4 story condominium building located at 930 6 Ave SW, Calgary, AB. The building was constructed in 2005 and the system may be original aside from the panel and some deficiency replacements.

System Specifications[edit | edit source]

FACP[edit | edit source]

The building is protected by a Mircom FX-2000 addressable fire alarm system. The panel is located in the main floor boiler room. The system runs Mircom's Advanced addressable protocol, and the system coding is temporal.

Annunciators[edit | edit source]

There is a Mircom RAX-LCD annunciator located at the front entrance.

Notification Appliances[edit | edit source]

Most notification appliances are System Sensor "SpectrAlert" P1224MCKA weatherproof horn/strobes (red, wall-mount, set to electromechanical, 75cd).

There are some System Sensor "L-Series" P2RLA horn/strobes (red, wall-mount, set to 15cd/electromechanical) as deficiency replacements, due to the building being a walkup and the horn/strobes being exposed to the elements.

There is one Mircom FHS-400-RR horn/strobe (red, wall-mount, set to 15cd) in the boiler room.

Initiating Devices[edit | edit source]

Pull Stations[edit | edit source]

Most pull stations are in outdoor spaces. There are two Mircom MS-401 single-action conventional pull stations mounted at each stairwell/exit, wired to a Mircom MIX-M500DMAP dual monitor module mounted in the West stairwell on each floor to monitor each of the two pull stations on that floor.

Other pull stations consist of Mircom MS-401AP addressable single action pull stations, installed as deficiency replacements.

Automatic Detection Devices[edit | edit source]

There is a Mircom MIX-2251AP at the top of each stairwell, mounted on a System Sensor B210LPA bases.

EOLs[edit | edit source]

There are Mircom MP-300 end-of-line resistor plates on all signal circuits.