More actions
| System Specifications |
|---|
| FACP: Notifier NFS2-640C FACP Location: Main Floor Storage Room System Type: Single-Stage Conventional System Line Voltage: 120VAC NAC Voltage: 24VDC System Coding: Temporal Strobes Synchronized: N/A Date of last known Upgrade: 2018 Year Opened: 1964 |
Didsbury District Health Services is the primary healthcare complex for a portion of south-central Alberta. The complex is owned and operated by Alberta Health Services. This page will cover Unit 3, located at 1210 20 Ave, in Didsbury, Alberta, Canada. The building was built in 1964 as an extended-care wing, and was decommissioned in 2018. The fire alarm system was upgraded in 1984, and had a panel replacement in 2018. This system was converted to single-stage operation after being decommissioned, as occupancy no longer required a two-stage system.
System Specifications (2018-present)
FACP
The building is protected by a Notifier NFS2-640C conventional fire alarm system. The panel is located in the main floor storage room. The system utilizes Notifier XP6-MAA addressable zone module cards to accommodate all conventional devices, and the system coding is temporal.
Annunciators
There is a Notifier NCA-2C annunciator at the main desk.
Notification Appliances
Most notification appliances are Edwards 439D-6AWC vibrating bells (6” gong).
Some areas have Notifier KMS-6-24A motor bells (6” gong).
Some areas have Edwards 439D-10AWC vibrating bells (10” gong).
Some areas have Mircom BL-6B motor bells (6” gong).
Initiating Devices
Pull Stations
Most pull stations are a mix of Edwards 270-GAO and 274-112 conventional two-stage single-action pull stations.
Some areas have Edwards 270-SPO conventional single-action pull stations.
There are Fire-Lite MPS-950BF and Mircom MS-401 conventional single-action pull stations in some areas as deficiency replacements.
Automatic Detection Devices
There are System Sensor C2W-BA conventional photoelectric and EST EDW1400A conventional ionization smoke detectors in all corridors and patient rooms.
There are a mix of the following conventional 135°F fixed-temperature/rate of rise heat detectors in almost all rooms: System Sensor 5601A, Edwards 281A, Edwards 281C, Edwards 245A, FDD CR-135 and Potter CR-135W.
Modules
There is a Notifier XP6-RA addressable relay card in the main FACP.
EOLs
There are Edwards EOL-P1 end of line resistor plates on all circuits.