Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

Capital Centre

From FireAlarmPedia
Revision as of 16:30, 3 May 2026 by TwentyThree33 (talk | contribs) (Created page with "{| style="float:right;border:2px solid black" |- ! System Specifications |- | |- | FACP: Mircom FA-1000<br />FACP Location: Main Entrance<br />System Type: Single-Stage Conventional<br />System Line Voltage: 120VAC<br />NAC Voltage: 24VFWR<br />System Coding: Temporal?<br>Strobes Synchronized: N/A<br />Date of last known Upgrade: N/A<br />Most Recent Known Modification: N/A<br />Year Opened: 1989 |} '''Capital Centre''' is an office building located at 100 3 Ave SE, in...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
System Specifications
FACP: Mircom FA-1000
FACP Location: Main Entrance
System Type: Single-Stage Conventional
System Line Voltage: 120VAC
NAC Voltage: 24VFWR
System Coding: Temporal?
Strobes Synchronized: N/A
Date of last known Upgrade: N/A
Most Recent Known Modification: N/A
Year Opened: 1989

Capital Centre is an office building located at 100 3 Ave SE, in Calgary, Alberta, Canada. The building was built in 1989, and the fire alarm system is mostly original.

System Specifications

FACP

The building is protected by a Mircom FA-1000 conventional fire alarm system. The panel is located at the main entrance. The system coding is likely temporal.

Notification Appliances

All notification appliances are Edwards 439D-10AWC vibrating bells (10" gong).

Initiating Devices

Pull Stations

All pull stations are Edwards 275-C111 conventional single-action pull stations.

Automatic Detection Devices

There are System Sensor C2W-BA conventional photoelectric smoke detectors at the top of each stairwell.
There are FDD CR-135 conventional 135°F fixed-temperature/rate-of-rise heat detectors at the top of the elevator shaft and in the basement electrical room.
There is a System Sensor "Innovair Flex" D2A conventional photoelectric duct smoke detector on the 3rd floor ductwork.

EOLs

There are Edwards EOL-P1 end of line resistor plates on all circuits.