More actions
| System Specifications |
|---|
| FACP: EST QuickStart QS4
FACP Location: Behind Front Desk System Coding: Likely Temporal |
Miette Hot Springs is a tourist attraction in Jasper National Park, AB. It is an outdoor hot pool with two pools. The building also has a restaurant, and a souvenir gift shop. The building was built in 1986, and most of the notification appliances, one pull station and most smoke detectors are original.
System Specifications
FACP
The building is protected by an EST QuickStart QS4 conventional fire alarm system. The panel is located behind the front desk, and replaced an Edwards 2280 in 2007 following a renovation. The system coding is likely temporal.
Notification Appliances
All notification appliances except for one are Edwards 439D-6AWC vibrating bells (6" gong). These are original to the building. There is a Notifier KMS-10-24A motor bell (10" gong) outside facing the pools as a deficiency replacement.
Initiating Devices
Pull Stations
All pull stations except for one are Mircom MS-401 conventional pull stations. Most were installed following the renovation, and there are a few newer variants as deficiency replacements. There is one Edwards 270-SPOB conventional pull station by the staff room, which is likely original.
Automatic Detection Devices
The smoke detectors are mainly Edwards EDW1451A ionization smoke detectors. One of them was replaced with a System Sensor C2W-BA i3 photoelectric smoke detector. The heat detectors are are Edwards 281B-PL.
Most smoke detectors are System Sensor 1412B direct-wire ionization smoke detectors. There is one Mircom "i3" 2W-BA photoelectric smoke detector as a deficiency replacement. The heat detectors are Edwards 281C fixed-temp/rate-of-rise heat detectors, which have likely been replaced as they were recalled in 2020.