More actions
| System Specifications |
|---|
| FACP: Notifier NFS2-640C FACP Location: Unknown System Type: Single-Stage Addressable System Line Voltage: 120VAC NAC Voltage: 24VDC System Coding: Temporal Strobes Synchronized: Yes, System Sensor Date of last known Upgrade: 2016 Year Opened: 1904 |
110 11 Ave SE is the address of a building in Downtown Calgary, Alberta, Canada. The building formerly housed the Inn from the Cold shelter from 2008 to 2022. The building was built in 1904, and the fire alarm system was upgraded in 1996, and again in 2016.
System Specifications (2016-present)[edit | edit source]
FACP[edit | edit source]
The building is protected by a Notifier NFS2-640C addressable fire alarm system. The panel location is unknown. The system runs Notifier’s FlashScan addressable protocol, and the system coding is temporal.
Notification Appliances[edit | edit source]
All notification appliances are System Sensor “SpectrAlert Advance” P2RA horn/strobes (red, wall-mount, set to 15cd).
Initiating Devices[edit | edit source]
Pull Stations[edit | edit source]
All pull stations are Notifier NBG-12LX addressable dual-action pull stations.
Automatic Detection Devices[edit | edit source]
There are Notifier FSP-851A addressable photoelectric smoke detectors throughout the building, mounted on System Sensor B210LPA bases.
Modules[edit | edit source]
There are Notifier FMM-1A addressable monitor modules supervising the sprinkler system’s tamper and flow switches.
System Specifications (1996-2016)[edit | edit source]
| System Specifications |
|---|
| FACP: Notifier AFP-400 FACP Location: Unknown System Type: Addressable System Line Voltage: 120VAC NAC Voltage: 24VDC System Coding: Unknown Strobes Synchronized: No Year Installed: 1996 Year Decommissioned: 2016 |
FACP[edit | edit source]
The building was protected by a Notifier AFP-400 addressable fire alarm system. The panel location was unknown. The system ran Notifier’s CLIP addressable protocol, and the system coding was likely continuous.
Notification Appliances[edit | edit source]
All notification appliances were System Sensor MASS24LO sounder/strobes (red, wall-mount, 1.5cd, set to 800Hz).
Initiating Devices[edit | edit source]
Pull Stations[edit | edit source]
All pull stations were Notifier NFM-950B conventional single-action pull stations. All stations had Notifier MMX-101A addressable monitor modules attached to them.
Automatic Detection Devices[edit | edit source]
There were Notifier CPX-551A addressable ionization smoke detectors throughout the building, mounted on Notifier BX501 bases.
Modules[edit | edit source]
There were Notifier MMX-1A addressable monitor modules supervising the sprinkler system’s tamper and flow switches.