More actions
| System Specifications |
|---|
| FACP: Notifier NFS-320C FACP Location: Unknown System Type: Single-Stage Addressable System Line Voltage: 120VAC NAC Voltage: 24VDC System Coding: Temporal Strobes Synchronized: Yes, SS Date of last known Upgrade: 2020? Year Opened: Unknown |
504 Patricia St is the address given to a small building in Jasper, AB. Its tenants are Scoops & Loops, The Raven Bistro and 3 Sheets Jasper. It is unknown when the building was built, but the fire alarm system was upgraded around 2020.
System Specifications (2020-present)[edit | edit source]
FACP[edit | edit source]
The building is protected by a Notifier NFS-320C addressable fire alarm system. The panel location is unknown. The system runs Notifier’s FlashScan addressable protocol, and the system coding is temporal.
Notification Appliances[edit | edit source]
All notification appliances are System Sensor “L-Series” P2RLA horn/strobes (red, wall-mount, set to 15cd).
Initiating Devices[edit | edit source]
Pull Stations[edit | edit source]
All pull stations are Notifier NBG-12LX addressable dual-action pull stations.
Automatic Detection Devices[edit | edit source]
There is a Notifier FST-851A addressable thermal heat detector in 3 Sheets Jasper, mounted on a System Sensor B210LPA base.
EOLs[edit | edit source]
There are Notifier EOL-CR end of line resistor plates on all signal circuits.
Former System Specifications (1990s-2020)[edit | edit source]
| Former System Specifications |
|---|
| FACP: Notifier SFP-400B FACP Location: Unknown System Type: Single-Stage Conventional System Line Voltage: 120VAC NAC Voltage: 24VDC System Coding: Continuous Strobes Synchronized: No Date of last known Upgrade: 1990s Year Decommissioned: 2020 |
FACP[edit | edit source]
The building was protected by a Notifier SFP-400B conventional fire alarm system. The panel location was unknown. The system coding was continuous.
Notification Appliances[edit | edit source]
All notification appliances were System Sensor “Multi-Alert Sounder/Strobe” MASS24LO sounder/strobes (red, wall-mount, 1.5cd). These were set to 800Hz continuous.
Initiating Devices[edit | edit source]
Pull Stations[edit | edit source]
All pull stations were Notifier NFM-950B conventional pull stations.
Automatic Detection Devices[edit | edit source]
There was an FDD CR-135 conventional 135°F fixedt-temperature/rate-of-rise heat detector in 3 Sheets Jasper.
EOLs[edit | edit source]
There were Notifier EOL-CR end of line resistor plates on all signal circuits.