More actions
| System Specifications |
|---|
| FACP: Mircom FA-1000 FACP Location: 3366 Entrance Vestibule System Type: Single-Stage Conventional System Line Voltage: 120VAC NAC Voltage: 24VFWR System Coding: Temporal Strobes Synchronized: No Date of last known Upgrade: 2010s Year Opened: 1953 |
Spruce Ridge Estates is a set of apartment buildings located on Spruce Drive SW, Calgary, AB. This page will cover buildings 3366 and 3368, respectively. The buildings were built in 1953, and the fire alarm system was upgraded in 1998.
System Specifications (1998-present)[edit | edit source]
FACP[edit | edit source]
The buildings are protected by a Mircom FA-1000 conventional fire alarm system. The panel is located in 3366’s entrance vestibule. The system coding is continuous.
The FA-1000 replaced a Notifier System 500.
Notification Appliances[edit | edit source]
All common area notification appliances are System Sensor “SpectrAlert” P2415A horn/strobes (red, wall-mount, 15cd).
There is a System Sensor “SpectrAlert Advance” P2RA horn/strobe (red, wall-mount, set to 15cd) in the mechanical room as a deficiency replacement.
Each suite has a System Sensor PA400SR-A mini-horn (red, silenceable) with a System Sensor S2415A remote strobe (red, wall-mount, 15cd).
Initiating Devices[edit | edit source]
Pull Stations[edit | edit source]
Most pull stations are Notifier NFM-950B conventional single-action pull stations.
There are Notifier MPS-950B conventional single-action pull stations and Mircom MS-401 conventional single-action pull stations as deficiency replacements.
Automatic Detection Devices[edit | edit source]
There are System Sensor “i3” C2W-BA conventional photoelectric smoke detectors in most areas.
There is a System Sensor DH100PA conventional photoelectric duct smoke detector on one MUA.
The other MUA has a System Sensor D2A conventional photoelectric duct smoke detector.
There is an FDD CR-135 conventional 135॰F fixed-temperature/rate-of-rise heat detector in the under-stair storage.
The mechanical room has a Mircom TD-200 conventional 200॰F fixed-temperature heat detector.
EOLs[edit | edit source]
There are Notifier EOL-CR end-of-line resistor plates on all circuits.