Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

1109 on 17th

From FireAlarmPedia
System Specifications
FACP: Mircom FA-1000
FACP Location: Main Entrance Vestibule
System Type: Single-Stage Conventional
System Line Voltage: 120VAC
NAC Voltage: 24VFWR
System Coding: Temporal
Strobes Synchronized: N/A
Date of last known Upgrade: N/A
Most Recent Known Modification: N/A
Year Opened: 1980

1109 on 17th is a low-rise office building located at 1109 17 Ave SW, in Calgary, Alberta, Canada. The first floor of the building has a retail space occupied by Watchman's Pub. The building was built in 1980, and the fire alarm system is partially original.

System Specifications

FACP

The building is protected by a Mircom FA-1000 conventional fire alarm system. The panel is located in the main entrance vestibule. The system coding is temporal.
This panel replaced an Edwards Custom 6500 in 2013.

Notification Appliances

Most notification appliances are Edwards "Durabel" 6100D vibrating bells (6" gong).
Some areas have Edwards 439D-6AWC vibrating bells (6" gong) and Mircom BL-6B motor bells (6" gong) as deficiency replacements.

Initiating Devices

Pull Stations

Most pull stations are Edwards 270-SPO conventional single-action pull stations.
There is an Edwards CCS-642 conventional single-action pull station in Watchmans, also original.
There are a mix of Mircom MS-401, Notifier MPS-950B, and Notifier NFM-950B conventional single-action pull stations as deficiency replacements.

Automatic Detection Devices

There are FDD CR-135 conventional 135°F fixed-temperature/rate-of-rise heat detectors in the penthouse common area and at the top of each stairwell.
There is an FDD CF-200 conventional 200°F fixed-temperature heat detector in the elevator machine room.
There are System Sensor "Innovair Flex" D2A conventional photoelectric duct smoke detectors on all air handling units.
The Watchmans kitchen suppression system is connected to the fire alarm system.

EOLs

There are a mix of Edwards EOL-P1 and Mircom MP-300 end of line resistor plates on all circuits.