More actions
| System Specifications |
|---|
| FACP: Notifier NFS2-640C FACP Location: Main Lobby System Type: Single-Stage Addressable System Line Voltage: 120VAC NAC Voltage: 24VDC System Coding: Temporal Strobes Synchronized: Yes, System Sensor Date of last known Upgrade: 2010s Year Opened: 1969 |
Sir John Franklin is a 16-story apartment building located at 11111 87 Ave NW, Edmonton, Alberta. It was built in 1969, and the fire alarm system was upgraded around 1999, with a panel replacement in the 2010s.
System Specifications (1999-present)[edit | edit source]
FACP[edit | edit source]
The building is protected by a Notifier NFS2-640C addressable fire alarm system. The panel is located in the main lobby at the rear hallway. The system runs Notifier’s CLIP addressable protocol, and the system coding is temporal.
The NFS2-640C replaced a Notifier AFP-400 around 2016.
Annunciators[edit | edit source]
There is a Notifier LCD-80 annunciator in the main entrance vestibule.
Notification Appliances[edit | edit source]
All notification appliances are System Sensor “SpectrAlert” P2415A horn/strobes (red, wall-mount, 15cd, set to electromechanical).
Initiating Devices[edit | edit source]
Pull Stations[edit | edit source]
All pull stations are Notifier NFM-950B conventional single-action pull stations. These are wired to Notifier MMX-101A addressable monitor modules, located behind each station.
Automatic Detection Devices[edit | edit source]
All smoke detectors on all floors except for the main floor are Notifier CPX-551A addressable ionization smoke detectors.
The office has a Notifier FSP-751A addressable photoelectric smoke detector installed as a deficiency replacement.
All above detectors are mounted on System Sensor BX501 bases.
The main lobby has a Notifier FSP-851A addressable photoelectric smoke detector as a deficiency replacement, mounted on a System Sensor B210LPA base.
The garbage chute corridor has an FDD CF135 conventional 135°F fixed-temperature heat detector, and a System Sensor 5603A conventional 135°F fixed-temperature heat detector installed as a deficiency replacement. Both detectors are wired to Notifier MMX-101A addressable monitor modules.
Modules[edit | edit source]
There are Notifier MMX-1A addressable monitor modules supervising the main floor sprinkler system's tamper and flow switches.
There are Notifier FRM-1A addressable relays for elevator recall.
There are Notifier ISO-XA isolator modules on each floor.
EOLs[edit | edit source]
There are Edwards EOL-P1 end-of-line resistor plates on all sprinkler and signal circuits.