Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

Mail is now working! Feel free to request an account. Accounts are available to invested enthusiasts/technicians in the industry. :)

Altalink Janet Service Centre

From FireAlarmPedia
System Specifications
FACP: Mircom FX-2000
FACP Location: Main Electrical Room
System Type: Single-Stage Addressable
System Line Voltage: 120VAC
NAC Voltage: 24VFWR
System Coding: Temporal
Strobes Synchronized: Yes, Mircom
Date of last known Upgrade: N/A
Most Recent Known Modification: N/A
Year Opened: 2019

Altalink is an Alberta-based power company. This page will cover the Janet Service Centre, located at 285205 Range Road 285, in Rocky View, Alberta, Canada. The building was built in 2019, and the fire alarm system is original.

System Specifications

FACP

The building is protected by a Mircom FX-2000 addressable fire alarm system. The panel is located in the main electrical room on the second floor. The system runs Mircom's Advanced addressable protocol, and the system coding is temporal.

Annunciators

There is a Mircom RAX-LCD annunciator paired with a Mircom RAX-1048TZDS annunciator in the main entrance vestibule. Both annunciators are mounted in a Mircom BB-1002 enclosure.

Notification Appliances

Most indoor notification appliances are Mircom FHS-400-RR horn/strobes (red, wall-mount, set to various candelas).
Some areas have Mircom FHS-400C-RR horn/strobes (red, ceiling-mount, set to 15cd).
For outdoor notification, there is a Mircom FS-400-RR-WP weatherproof remote strobe (red) outside the main entrance, and there are System Sensor "SpectrAlert Advance" P2RKA weatherproof horn/strobes (red, wall-mount) on the roof at both exits.

Initiating Devices

Pull Stations

All indoor pull stations are Mircom MS-401AP addressable single-action pull stations.
The rooftop has Mircom MS-401 conventional single-action pull stations wired to Mircom MIX-M501MAPA addressable modules.

Automatic Detection Devices

There are Mircom MIX-2251APA addressable photoelectric smoke detectors at the top of each stairwell, in all elevator lobbies, in the elevator electrical room, and at the top of each elevator shaft.
There are Mircom MIX-5251RAPA addressable 135°F fixed-temperature/rate-of-rise heat detectors in all mechanical and electrical rooms.
All aforementioned detectors are mounted on System Sensor B210LPA bases.
There are System Sensor DNRA duct smoke detector housings equipped with Mircom MIX-2251APA addressable photoelectric heads on all air handling and rooftop units.

Modules

There are Mircom MIX-M500MAPA addressable monitor modules supervising the pre-action system's trouble contacts, the generator's run/trouble contacts, the fire pump's run/trouble contacts, the fire pump pond low water level contacts, and the sprinkler system's tamper and flow switches.
There is a Mircom MIX-M500DMAPA addressable dual-input monitor module supervising the pre-action system's supervisory and alarm contacts.
There are Mircom MIX-M500RAPA addressable relay modules serving various purposes.
There are System Sensor M500XA isolator modules on the SLCs.
There are three Mircom SDM-240 sync modules synchronizing all horn/strobes.

EOLs

There are Mircom MP-300 end of line resistor plates on all circuits supervised by monitor modules, and on all signal circuits.