Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

Plaza 124

From FireAlarmPedia
System Specifications
FACP: Mircom FX-2000
FACP Location: Near Loading Dock
System Type: Single-Stage Addressable
System Line Voltage: 120VAC
NAC Voltage: 24VFWR
System Coding: Continuous
Strobes Synchronized: N/A
Date of last known Upgrade: 2012
Most Recent Known Modification: N/A
Year Opened: 1983

Plaza 124 is an office building located at 10216 124 St NW, in Edmonton, Alberta, Canada. The building was built in 1983, and the fire alarm system was upgraded in 2012; the notification appliances were not modified during this upgrade. See Bonus Information for additional upgrade info.

System Specifications (2012-present)

FACP

The building is protected by a Mircom FX-2000 addressable fire alarm system. The panel is located near the loading dock. The system runs Mircom's CLIP addressable protocol, and the system coding is continuous.
This panel replaced an Edwards ESA2000, which in turn replaced the original panel, a Mirtone 8000.

Annunciators

There is a Mircom RAX-LCD annunciator paired with a Mircom RAX-1048TZDS annunciator in the main entrance vestibule; both annunciators are mounted in a Mircom BB-1002 enclosure.

Notification Appliances

Most notification appliances are Edwards 439D-10AWC vibrating bells (10" gong); these are present on the 2nd floor and above.
The lobby and parkade have Mirtone 74303 vibrating bells (6" gong), original to the building.
Some tenant spaces have Edwards MB10-24 motor bells (10" gong).
There is an Edwards MB6-24 motor bell (6" gong) on the 4th floor as a deficiency replacement.

Initiating Devices

Pull Stations

All pull stations are Mircom MS-401AD addressable single-action pull stations.

Automatic Detection Devices

There are Mircom MIX-2251APA addressable photoelectric smoke detectors in all elevator lobbies and at the top of each stairwell.
There are Mircom MIX-5251RAPA addressable 135°F fixed-temperature/rate-of-rise heat detectors in the mechanical room.
All detectors are mounted on System Sensor B210LPA bases.

Modules

There are Mircom MIX-M500DMA addressable dual-input monitor modules supervising the sprinkler system's tamper and flow switches.
There are Mircom MIX-M500RA addressable relay modules serving various purposes.

EOLs

There are Mircom MP-300 end of line resistor plates on all sprinkler and signal circuits.

Bonus Information

This system may have been upgraded in stages; the FACP might have been an emergency replacement, and might have used conventional devices for a short period of time.