Toggle menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

We have switched hosting. Sorry for the recent downtime. :)

Banff Gondola (main building): Difference between revisions

From FireAlarmPedia
No edit summary
No edit summary
Line 11: Line 11:
== System Specifications (1998-present) ==
== System Specifications (1998-present) ==
==== FACP ====
==== FACP ====
The building is protected by a Notifier NFS2-640C conventional fire alarm system. The panel is located in the Starbucks, next to an emergency exit and near a fireplace. The panel has the NCA-2 display, and two zone cards in it; a Notifier XP6-MA 6-zone smoke detector card, as well as a Notifier XP-10MA 10-zone card. The system coding is likely continuous.
The building is protected by a Notifier NFS2-640C conventional fire alarm system. The panel is located in the Starbucks, next to an emergency exit and near a fireplace. The panel has the NCA-2 display, and two zone cards in it; a Notifier XP6-MA 6-zone smoke detector card, as well as a Notifier XP-10MA 10-zone card. The system coding is likely continuous.  


This panel replaced an EST 6616 in 2016, so each terminal can be networked.  
This panel replaced an EST 6616 in 2016, so each terminal can be networked.  
Line 31: Line 31:
[[]
[[]
[[]
[[]
[[Category:Alberta]]
[[Category:Tourist Attractions]]

Revision as of 17:29, 22 May 2024

This page covers the main building. For the upper terminal, see Banff Gondola Upper Terminal.

System Specifications
FACP: Notifier NFS2-640C
FACP Location: Starbucks
System Type: Conventional
System Line Voltage: 120VAC
NAC Voltage: 24VDC
System Coding: Continuous?
Strobes Synchronized: Yes, Self-sync
Date of last known Upgrade: 2016
Year Opened: 1997/1998

Banff Gondola is a tourist attraction located at 100 Mountain Ave, Banff, AB. It is a gondola ride on Sulphur Mountain with an amazing view. This page will cover the main building/lower terminal. It was builti in 1959, and rebuilt in 1998. The fire alarm system is 90% original.

System Specifications (1998-present)

FACP

The building is protected by a Notifier NFS2-640C conventional fire alarm system. The panel is located in the Starbucks, next to an emergency exit and near a fireplace. The panel has the NCA-2 display, and two zone cards in it; a Notifier XP6-MA 6-zone smoke detector card, as well as a Notifier XP-10MA 10-zone card. The system coding is likely continuous.

This panel replaced an EST 6616 in 2016, so each terminal can be networked.

Notification Appliances

Most notification appliances are Edwards 439D-6AWC vibrating bells (6" gong).

These can be found in three different setups: remotely (no strobe), on an EST 403-5A-R strobe plate (15cd), or with an EST 202-5A-T strobe (red, wall-mount, 15cd) next to it, the latter is more common.

By the main entrance, there is an Edwards MB6-24 motor bell (6" gong) as a deficiency replacement.

Some areas have Edwards 202-5A-T remote strobes (15cd, red, wall-mount) for additional coverage.

The gondola boarding area has an Edwards 439D-10AWC vibrating bell (10" gong), with a 202-5A-T strobe next to it due to higher ambient noise levels.

Initiating Devices

Pull Stations

All pull stations are Edwards 270-SPO conventional single-action pull stations.

Automatic Detection Devices

There are System Sensor 1451A ionization smoke detectors throughout the building, as well as some System Sensor 5601A 135-degree fixed/rate-of-rise heat detectors in the main lobby, restrooms, and other areas. The heat detectors were installed in 2021, replacing Edwards 281C rate-of-rise/fixed heat detectors due to a recall.

Recent Replacements

In 2021, the Edwards 281C heat detectors were replaced with System Sensor 5601A heat detectors, due to a recall affecting the Edwards detectors. [[] [[]